Recently acquired a Farmingdale '66 carbine. Looks almost new. How tightly is the pressure plat supposed to fit in the block? Mine is tight--requires use of small screwdrivers in slots to remove from block. No sign of rust, damage or corrosion on the block or plate.
Any thoughts appreciated.
Steve K
pressure plate
-
- Posts: 179
- Joined: Thu Mar 25, 2004 4:15 pm
- Location: asheville
pressure plate
If at first you don't secede, try, try again.
-
- Posts: 38
- Joined: Sun Dec 26, 2010 11:23 am
- Location: SW VA
Re: pressure plate
the plates on both my carbine and rifle are tight as are yours
-
- Moderator
- Posts: 2136
- Joined: Fri Sep 20, 2002 7:47 pm
- Location: Big Timber
Re: pressure plate
It is fine, after every time you shoot, take it, along with the cleanout screw and the nipple out and clean them. Use anti-sieze for assembly