Sights/Scope Problem
Posted: Tue Mar 23, 2004 8:34 pm
I have a hard to describe problem with my Hartford Model, in regards to the sights and/or scope. When I bought the rifle, I had Shiloh install the MVA sights, and everything looked fine and centered. When I shot the rifle however, I found that it was always hitting to the right, so I had to adjust the sights over, as if there was a lot of wind or they (sights) were not properly centered onto the barrel. Then I replace the sights with a RHO scope and run into the same problem. The mounts are dead nuts equal, when measured from the end of the mount to the edge of the barrel. When both bore sighted as well as shot, the gun would always shoot to the right. The mount had to be adjusted (moved over) around a .10" to be on zero with the target. I realize that a little bit off is fine, but to be a tenth off seems a little extreme in both with factory installed sights and a home installed scope. Is this normal or any idea what could cause this?
Thanks...Sackett
Thanks...Sackett