Trigger plate bent?
-
- Posts: 334
- Joined: Wed Apr 23, 2003 12:13 pm
- Location: great northwest
Trigger plate bent?
Can the cast trigger plate be bent slightly?? The Shilo I just purchased has a slight warp to the plate. I would like to bend it slightly to make it lay flat at the tip. It is currently just under 1/16" out at the tip. I'm refinishing the stock and noticed some "extra" finish or bedding under it and removed it. It will now lay flat but the other end (where it screws to the frame) is out 1/8". It will probably spring that much but I haven't tried as I'm not ready to reassemble yet.