Mould Restoration

Discussions of powders, bullets and loading information.

Moderators: Kirk, Lucinda

PhilRich
Posts: 38
Joined: Tue Jan 03, 2017 4:06 pm

Re: Mould Restoration

Post by PhilRich » Mon Apr 22, 2019 8:46 pm

arnie wrote:
Mon Apr 15, 2019 9:33 pm
I have found what works best for me to release a bullet from the mould . After cutting the sprue ,press the lower left rear corner down on your bench and put pressure on the upper right front corner with a piece of wood (mould mallet ) and at the same time open the handles and the bullet will rotate slightly and fall out .This is similar to what Paul Jones recommends .
I tried this method today, and it works fine. Thanks for the info!

Post Reply