Looking for something else, I ran across this in the Spring 2003 BPCN .....
"I went through my references on the percussion Sharps and could find no cautions as to air space the chamber when using either paper cartridges or loose powder and ball.
There was more emphasis placed on the necessity of having the bullet greased with tallow.
In my experience with the Shiloh rifle, I used 1Fg to bulk up the 120-grain chamber along with two heavy felt wads soaked with grease. This combination cut the charge back to about 75 grs, which was all the fun I wanted.
The .54 Shiloh shot very well, even out to 500 yards." SPG
This in response to a reader's letter in whih he described his .54 paper cartridge load of 60-90 grs FFg, separator disk and farina as a filler behind the bullet.
The writer said that "the farina and powder will mix in the chamber/breech block when I jostle the rifle around." Huh?
Sounds to me like he had a chamber-length cartridge with that load, so there ought not to be any shearing action when the block was raised.
I tried some .54 loads with 75 grs FFg and cream of wheat filler (no separator), and while they shot well with no problems I was aware of, I saw no advantage to warrant the use of the filler.
Now that I've discovered that 24 ga greased wads fit the chamber, I'd like to try seating a lubed bullet, followed by a 1/2 24 ga wad and a paper cartridge with the charge.
SPG's loads for .54 '63 Shiloh
-
- Posts: 2133
- Joined: Wed Mar 03, 2004 12:01 pm
- Location: Somewhere in the Cariboo ....
SPG's loads for .54 '63 Shiloh
"From birth to the packing house, we travel between the two eternities ....." Robert Duvall in "Broken Trail"
-
- Posts: 610
- Joined: Thu Sep 26, 2002 7:53 am
- Location: Maine
-
- Posts: 2133
- Joined: Wed Mar 03, 2004 12:01 pm
- Location: Somewhere in the Cariboo ....
24 ga wads
Rich
I got mine from Ballistic Products. Any company that sells odd ball shotgun reloading supplies will stock them - lubed or unlubed.
Bear in mind that they are a SNUG fit in a clean .54 chamber, requiring use of a short starter. Might be a way of chamber cleaning between rds as well as bore scrubbing.
I got mine from Ballistic Products. Any company that sells odd ball shotgun reloading supplies will stock them - lubed or unlubed.
Bear in mind that they are a SNUG fit in a clean .54 chamber, requiring use of a short starter. Might be a way of chamber cleaning between rds as well as bore scrubbing.
"From birth to the packing house, we travel between the two eternities ....." Robert Duvall in "Broken Trail"
-
- Posts: 2133
- Joined: Wed Mar 03, 2004 12:01 pm
- Location: Somewhere in the Cariboo ....
24 ga wads
Rooster
With that huge 120 gr powder chamber, you'll be able to use a whole 24 ga wad and still have useable powder space.
I have to cut mine in half. Makes more sense to me than using a loose filler.
With that huge 120 gr powder chamber, you'll be able to use a whole 24 ga wad and still have useable powder space.
I have to cut mine in half. Makes more sense to me than using a loose filler.
"From birth to the packing house, we travel between the two eternities ....." Robert Duvall in "Broken Trail"