Page 1 of 1
Dimensions of barrel shank and threads?
Posted: Wed Jul 20, 2011 7:58 pm
by Naphtali
- What are the dimensions of the barrel where it is breeched?
- What are breech thread specifications?
- What are the differences between the previously identified dimensions for Model 1863 barrels and Model 1874 barrels?
Re: Dimensions of barrel shank and threads?
Posted: Sun Aug 28, 2011 10:45 am
by KL
The NRA published a book on riflesmithing perhaps 40 years ago in large format softcover. It contains perhaps 80 (?) diagrams of thread patterns, sizes, and barrel shank dimensions. It has one on the Sharps. Find it and look for what you need there. If you want the information for rebarreling purposes, the existing dimensions can easily be copied from the old barrel after it has been removed.
Re: Dimensions of barrel shank and threads?
Posted: Sat Sep 10, 2011 9:11 am
by Naphtali
FOUND! in Single Shot Rifles and Actions, De Haas, Frank, Gun Digest Company, 1969. Page 330.
Basis barrel O.D. = 1.24 inches
Thread and barrel shank O.D. = .760 inch with 10 t.p.i. square threads
Basis chamber O.D. = 1.127 inch
Re: Dimensions of barrel shank and threads?
Posted: Wed Oct 05, 2011 9:06 pm
by KL
The book I was referring to is titled The NRA Gunsmithing Guide--Updated, copyright 1982. It lists an OD of 1.238. The Sharps Borchardt is quite different. Lots of good stuff in that book.
Re: Dimensions of barrel shank and threads?
Posted: Thu Oct 06, 2011 7:15 am
by Kirk
The O.D. of the threaded shank is 1.130". It has 10 T.P.I. and is .750 long to the shoulder which is 1.250."
Re: Dimensions of barrel shank and threads?
Posted: Thu Oct 06, 2011 9:59 am
by Naphtali
Kirk:
Many thanks for correcting my dimensions.