Proof load questions
-
- Posts: 60
- Joined: Sat Apr 18, 2020 2:14 pm
- Location: Indiana
Proof load questions
I’m currently restoring a M1866 Allin trapdoor as much as I can. Everything looks sound in it. Should I proof it a couple of times before using it as a shooter? Just how do go about making the proof rounds in .50-70 with its fixed capacity?
-
- Posts: 668
- Joined: Sun May 25, 2003 7:48 pm
- Location: Saint Cloud, MN
Re: Proof load questions
Personally, I would only shoot black powder in an old original gun.
If a competent gunsmith looks it over for "issues" and pronounces it sound,
there should be no need for proof charges.
Keep on hav'n fun!
MikeT
If a competent gunsmith looks it over for "issues" and pronounces it sound,
there should be no need for proof charges.
Keep on hav'n fun!
MikeT
-
- Posts: 60
- Joined: Sat Apr 18, 2020 2:14 pm
- Location: Indiana
Re: Proof load questions
I should have mentioned my intent to only use BP. Finding a competent gunsmith in my area is not easy. Last one I visited, I knew more about this than he did. Thus my desire to proof it from a safe distance.
-
- Posts: 442
- Joined: Tue Jun 16, 2015 10:53 am
Re: Proof load questions
My way of "testing" or proofing an old rifle that I have questions about is to load up 3 or so "standard rounds" for the rifle. By standard I would say 70 grains of FFg and a 450 grain bullet for the military 50-70. Then get an old tyre, put the butt inside one side and tie the front end of the rifle down to the opposit side of the tyre. Get a 25 or 30 foot piece of small diameter cord (parachute cord) and tie one end to the trigger. I seem to recall that the old Dixie catelogs showed this somewhere in the back if you need a picture. Load it up pointed in a safe direction, duck behind something and give the cord a yank. If the rifle doesn't come apart on the first round, give the brass a really critical study to look for problems. If the brass looks good, just to be sure, do the same with a couple more rounds. If all holds together you are probably good to go.
Liability suits being what they are, you do this at your own risk. I accept no responsibility for anything I just said!
George
Liability suits being what they are, you do this at your own risk. I accept no responsibility for anything I just said!
George
-
- Posts: 270
- Joined: Wed Feb 14, 2018 4:18 pm
- Location: Nine Mile Falls Wa
Re: Proof load questions
Could do a chamber cast too and check the measurements first.